Eurotherm 3116 PID Betriebsanweisung PDF herunterladen (Seite 6)

3116 User Guide Part No. HA028005ENG Issue 2.0 May 04

ENG

1.3 Step 1: Installation

This instrument is intended for permanent installation, for indoor use only, and enclosed in an electrical panel

Select a location which is subject to minimum vibrations and the ambient temperature is within 0 and 55

C (32 - 122

The instrument can be mounted on a panel up to 15mm thick

To ensure IP65 and NEMA 4 front protection, mount on a non-textured surface.

Please read the safety information in section 4 before proceeding and refer to the EMC Booklet part number HA025464

for further installation information.

1.3.1 Panel Mounting the Controller

1. Prepare a square cut-out in the mounting panel to the size

shown. If a number of controllers are to be mounted in

the same panel they should be spaced as shown.

2. Fit the IP65 sealing gasket, if required, behind the front

bezel of the controller

3. Insert the controller through the cut-out

4. Spring the panel retaining clips into place. Secure the

controller in position by holding it level and pushing both

retaining clips forward.

5. Peel off the protective cover from the display

1.3.2 To Remove the Controller from its Sleeve

The controller can be unplugged from its sleeve by easing the

latching ears outwards and pulling it forward out of the sleeve.

When plugging it back into its sleeve, ensure that the latching ears click back into place to maintain the IP65 sealing.

45 mm - 0.0 + 0.6

1.77 in -0.00, +0.02

10mm (0.4 in)

38mm (1.5 in)

(Not to scale)

Recommended minimum

spacing of controllers

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Keine Kommentare

Eurotherm 3116 PID Betriebsanweisung Seite 6